Geovision GV-NVR SYSTEM LITE V2 Manual de usuario descargar pdf (Pagina 47)

Chapter 4 Firmware Upgrade for GV IP Cameras

GeoVision will periodically release the updated firmware of GV IP camera on the website. The

new firmware can be simply loaded into the GV IP camera by using the Web interface of GV

IP camera or IP Device Utility of the GV-NVR System Lite V2.

Important Notes before You Start

Before you start updating the firmware, please read these important notes:

1. While the firmware is being updated,

A) the power supply of the camera must not be interrupted, and

B) do not unplug the Ethernet cable of the camera if the cable is the source of power

supply (Power over Ethernet or PoE supported).

2. Do not turn the camera power off in 10 minutes after the firmware is updated.

3. If you use the IP Device Utility for firmware upgrade, the GV-NVR System Lite V2 used to

upgrade firmware must be under the same network of the camera.

WARNING: The interruption of power supply during updating causes not only update

failures but also damages to the camera. In this case, please contact your sales

representative and send your device back to GeoVision for repair.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 85 86

Sin comentarios

Geovision GV-NVR SYSTEM LITE V2 Manual de usuario Pagina 47