Geovision GV-NVR SYSTEM LITE V2 Manual de usuario descargar pdf (Pagina 74)

Troubleshooting

Chapter 7 Troubleshooting

GV-NVR System Lite V2 is designed for durability. However, should problems occur, following

the procedures here can help determine the cause.

GV-NVR System Lite V2 won’t turn on.

If your GV-NVR System Lite V2 won’t turn on or you don't hear a startup sound or any fan or

drive noise, try these steps:

1. Make sure that you press the Power button. The power LED will turn blue when the

GV-NVR System Lite V2 is turned on.

Figure 7-1

2. Make sure that the power cord is properly connected to both GV-NVR System Lite V2 and

power outlet. If you are using a power strip, make sure that the strip is powered on.

3. If the problem persists, consult your dealer.

GV-NVR System Lite V2 stops responding (aka “crashed” or “froze”).

If your GV-NVR System Lite V2 is not responding to your clicking, typing, or mouse

movements, try to press the Power button on the GV-NVR System Lite V2 to turn it off. Wait

30 seconds and then press the Power button again to turn it on.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 85 86

Sin comentarios

Geovision GV-NVR SYSTEM LITE V2 Manual de usuario Pagina 74