Geovision GV-R1352 Guía de instalación descargar pdf (Pagina 16)

5.3 Configuring the Beeper and LED Settings for Each Door/Gate

After connecting the wires for beeper or LED, specify the conditions to trigger the beeper and

LED on the GV-AS210 / 2110 / 400 / 410 / 4110 / 810 / 8110 Web interface.

1. On the controller Web interface, click Output Setting. The page below appears.

2. Find the output wired to the beeper or LED and specify up to 2 alarm conditions to set off

the beeper or LED.

a. Output Type: Select Normal, Toggle or Pulse. If you select Pulse, you can specify

the number of seconds to trigger the beeper or LED.

b. Output Conditions: Select the door and the alarm conditions to trigger the beeper

or LED. Up to 2 sets of output conditions can be set.

3. If you have wired the beeper or LED to outputs 9 ~ 16 on GV-AS400, select a door and

select Beeper, Green LED, Red LED or Invert Red LED.

February 6, 2015

 Beeper: Enables the external control of Beeper.

 Green LED: Changes the standby color to blue. When a card is read, the LED

flashes green.

 RED LED: Changes the standby color to red. When a card is read, the LED flashes

blue.

 Invert Red LED: Changes the standby color to blue. When a card is granted access,

the LED flashes red.

4. Click Submit.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21

Sin comentarios

Geovision GV-R1352 Guía de instalación Pagina 16