Geovision GV-R1352 Guía de instalación descargar pdf (Pagina 17)

6. Setting UID or GID on GV-R/RK/DFR Config AP

By default, the readers read the UID (unique identifier) on ID cards or key fobs. Using GV-

R/RK/DFR Config AP, you can set the GV-RK1352 / GV-R1352 to read GID (GeoVision ID)

n GV-AS ID Cards / Key Fobs instead. o

Note:

1. To see how to install the Config AP and how to identify the COM port of the reader,

refer to 3. Installing GV-R/RK/DFR Config AP and 4.1 Defining the ID Number and

Setting the Reader to Slave earlier in this installation guide

2. GID ID format is only supported in GV-RK1352 / GV-R1352 V1.2 or later.

3. If you are using third-party cards or key fobs, you must set the reader to read UID.

Config AP. 1. Run GV-R/RK/DFR

2. Select the COM port that is connected to the reader and click Open COM. The serial

e to blue to indicate the COM port is correct.

er to read GID, select Only Read GID.

4. Click Setup to apply the setting.

number and firmware version of the reader will be automatically detected. The red square

next to the COM port box should chang

February 6, 2015

3. To set the read

1 2 ... 12 13 14 15 16 17 18 19 20 21

Sin comentarios

Geovision GV-R1352 Guía de instalación Pagina 17